Page 1 of 1
500 power requirement info.
Posted: Tue Feb 20, 2018 2:10 am
by Allertorguy02
I was just wondering if anyone knows the power requirement info for any variant of the 500 series. Any info is appreciated!
Sincerely,
Allertorguy02
Re: 500 power requirement info.
Posted: Tue Feb 20, 2018 2:11 am
by Tyler
Allertorguy02 wrote: ↑Tue Feb 20, 2018 2:10 am
I was just wondering if anyone knows the power requirement info for any variant of the 500 series. Any info is appreciated!
Sincerely,
Allertorguy02
240 single or 3 phase, or 480 3 phase.
Re: 500 power requirement info.
Posted: Tue Feb 20, 2018 2:12 am
by Allertorguy02
What about motor horsepower and amp draw with 240 3 phase.
Re: 500 power requirement info.
Posted: Tue Feb 20, 2018 2:54 am
by Brendan W
Motor horse I believe is 15.
Re: 500 power requirement info.
Posted: Wed Feb 21, 2018 4:58 am
by FS Rotor
10hp
Re: 500 power requirement info.
Posted: Wed Feb 21, 2018 4:01 pm
by Stormsetter4
The 9/12 dual tone and 5 or 8 port single tone models used a 10hp 3 phase 9-lead motor or a 10hp single phase repulsion-induction motor. The 3 phase motor drew 28 amps at 240v and 14 amps at 480v. The single phase motor drew 56 amps depending on the brush angle. The 10/12 500 is a bit of a mystery, as the rotor/stator was substantially bigger than the 9/12 port or 5/8 port single tone models. From what I understand it had a 15hp 3 phase motor which probably drew around 42-45 amps. I don’t know if the 10/12 version was available as a single phase model.